plant. Thursday , November 02nd , 2017 - 11:05:50 AM
Step 2 - To grow ginger effectively, plant them in spring for warm temperatures both indoors and outdoors. Keep in mind that dormant tubers will only sprout at 75 to 85 degrees F temperatures.
There are many useful products obtained from raspberries: Ice cream, jam, jelly, black raspberry petits fores, raspberry juice, and of course, fresh raspberry fruits.
For 7' or 10' tall trees, I use the bobcat or a ball-cart or tree-truck to transport the trees to just beside the holes, and lay them down. There is a knack to it, as you roll the root-ball into the hole, stand it up straight also. Most trees will need a slight adjustment, do this by prying up on the low side of the root-ball with 6' digging bars for 7' or 10' trees. What I call a digging bar is 6' or 7' long, every Lowes store has them, made of steel, they have a round knob or a point on one end and the other end is flattened to about 5" wide. You have to adjust the root-ball until the tree trunk is vertical; do not push on the trunk to straighten the tree. I have also used hay hooks; they are good to hook onto the wire basket also to straighten. I have only found aluminum hay hooks at Tractor Supply, but Augusta co-op in VA has steel hay hooks which are much stronger. For planting 36" root-ball trees, weighing 1,000 lbs and larger, it is better to let the machine place the trees. I hook a 7' chain across about 4 teeth on the bobcat bucket, and then hook the hooks onto the top strand of the wire basket almost straight across from each other. If you hook directly across it will cause the trunk to scrape against the bobcat bucket. If hooked about 3 or 4 inches less than directly across, the tree will travel at a slight angle as you approach the hole. As you lower the bucket and tree into the hole, have a man or two there pushing the tree so it is vertical as it touches down. Do not push on the trunk one the tree is resting in the hole. To straighten trees this size, use the chain on the bobcat bucket and hook to the low side of the wire basket, raise it until the trunk is straight. If you can get a root-ball to with a couple of degrees of straight by straightening , and the tree trunk still needs to be pulled over 3 inches or less, drive one stake opposite of where it is leaning, and pull the tree those few inches to be straight and tie to that stake. You can come back through after all the trees are planted and straight and drive the other stakes in and tie the other directions.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does Plants claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.